Cruise Control & Driver Assistance

Diagnosis and Repair Work Flow

9steps
~54min
3/5difficulty
Done 0 of 9
Work Flow

OVERALL SEQUENCE

DETAILED FLOW

INTERVIEW FOR MALFUNCTION

It is important to clarify the customer’s concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.

>>

GO TO 2.

SELF DIAGNOSTIC RESULT WITH CONSULT

  1. Select “Self Diagnostic Result” with CONSULT.

  2. Check if the DTC is detected on the “Self Diagnostic Result” mode of “LASER/RADAR”.

Is any DTC detected?

YES>>

Record or print self-diagnosis results and freeze frame data (FFD). GO TO 5.

NO>>

GO TO 3.

ACTION TEST

Perform the AEB system action test to check the system operation. Check if any other malfunctions occur.

>>

GO TO 4.

SYMPTOM DIAGNOSIS

Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to Symptom Table.

>>

GO TO 6.

TROUBLE DIAGNOSIS BY DTC

  1. Erase self-diagnostic results.

  2. Ignition switch OFF → ON.

  3. Check the DTC in the “Self Diagnostic Result”.

  4. Perform trouble diagnosis for the detected DTC. Refer to DTC Index.

>>

GO TO 6.

MALFUNCTIONING PART REPAIR

Repair or replace the identified malfunctioning parts.

>>

GO TO 7.

REPAIR CHECK (SELF DIAGNOSTIC RESULT WITH CONSULT)

  1. Erase “Self Diagnostic Result”.

  2. Select “Self Diagnostic Result” again after repairing or replacing the specific items.

  3. Check if any DTC is detected in “Self Diagnostic Result” mode of “LASER/RADAR”.

Is any DTC detected?

YES>>

GO TO 5.

NO>>

GO TO 8.

REPAIR CHECK (ACTION TEST)

Perform the AEB system action test. Check that the malfunction symptom is solved or no other symptoms occur.

Is there a malfunction symptom?

YES>>

GO TO 4.

NO>>

Inspection End.