Engine
Evap Canister
In this manual: Engine
6steps
~36min
2/5difficulty
Done 0 of 6
EVAP CANISTER

| 1. | EVAP canister control pressure sensor | 2. | EVAP canister | 3. | Shield |
| 4. | Clamp | 5. | EVAP canister purge hose | 6. | EVAP canister vent line |
| 7. | EVAP canister vent control valve hose | 8. | EVAP canister vent control valve | A. | O-ring |
REMOVAL
Remove shield (if necessary).
Disconnect EVAP canister purge hose, EVAP canister vent line, and EVAP canister vent control valve hose.
Disconnect the harness connectors from EVAP canister control pressure sensor and EVAP canister vent control valve.
Remove EVAP canister bolt.
Remove EVAP canister from the Nissan Murano vehicle.
INSTALLATION
Installation is in the reverse order of removal.
Check EVAP canister as follows:
Block port (A).

Blow air into port (B) and check that it flows freely out of port (C).
Release blocked port (A).
Apply vacuum pressure to port (A) and check that vacuum pressure exists at the ports (B) and (C).
Block port (B) and (A).
Apply vacuum pressure to port (C) and check that there is no leakage.
Was this page helpful?