Driver Controls

Front Fog Lamp Aiming Adjustment

~2min read
Aiming Adjustment

PREPARATION BEFORE ADJUSTING

The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb. Before performing aiming adjustment procedure, check the following:

  • Ensure all tires are inflated to correct pressure.

  • Place vehicle and screen on level surface.

  • Ensure there is no load in vehicle other than the driver (or equivalent weight placed in driver's position).

  • Coolant and engine oil filled to correct level, and fuel tank full.

  • Remove cargo and/or luggage to maintain an unloaded vehicle condition.

  • Confirm spare tire, jack and tools are properly stowed.

  • Carefully wipe off any dirt from headlamp lens.

  • Place a driver or equivalent weight of 68.5 kg (150 lb) on the driver seat.

  • By hand, bounce the front and rear of the vehicle to settle the suspension and eliminate any static load.

  • Place the front tires in the straight ahead position.

  • Aim each headlamp individually and ensure other headlamp beam pattern is blocked from screen.

Aiming Adjustment Procedure

Place the screen.

Face the Nissan Murano vehicle with the screen. Maintain 7.62 m (25.0 ft) between the front fog lamp center and the screen.

Start the engine. Turn the front fog lamp ON.

Adjust aiming by turning the adjusting screw (A).

Adjust the cutoff line height (A) with the aiming adjustment screw so that the distance (X) between the horizontal center line of front fog lamp (H) and (A) becomes 100 mm (4 in).

A : Cutoff line
B : High illuminance area
H : Horizontal center line of front fog lamp
V : Vertical center line of front fog lamp
X : Cutoff line height