Driver Controls

Headlamp Aiming Adjustment

~3min read
Inspection

PREPARATION BEFORE ADJUSTING

Before performing aiming adjustment, check the following:

  • Make sure all tires are inflated to correct pressure.

  • Place vehicle and screen on level surface.

  • Make sure there is no load in Nissan Murano vehicle other than the driver (or equivalent weight placed in driver's position).

  • Coolant and engine oil filled to correct level, and fuel tank full.

  • Remove cargo and/or luggage to maintain an unloaded Nissan Murano vehicle condition.

  • Confirm spare tire, jack and tools are properly stowed.

  • Carefully wipe off any dirt from headlamp lens.

AIMING ADJUSTMENT SCREW

1. Front combination lamp (view from rear) A. Headlamp HI/LO (UP/DOWN) adjustment screw

Place a driver or equivalent weight of 68.5 kg (150 lb) on the driver seat.

By hand, bounce the front and rear of the Nissan Murano vehicle to settle the suspension and eliminate any static load.

Place the front tires in the straight ahead position.

Aim each headlamp individually and ensure other headlamp beam pattern is blocked from screen.

Aiming Adjustment Procedure

Aiming Chart

1. Adjustment screen A. Distance of horizontal aiming evaluation line from ground B. Maximum cutoff line height
C. Minimum cutoff line height D. Center of headlamp bulb E. 7.6 m (25 ft)
F. Maximum aim evaluation distance from vertical center on aiming screen 399 mm (15.7 in) [3°R] G. Minimum aim evaluation distance from vertical center on aiming screen 133 mm (5.2 in) [1°R] H. Aim evaluation area
J. Horizontal aiming evaluation line K. Vertical aiming evaluation line Right
B: (Maximum cutoff line height) 3.5 mm (0.138 in) 0.25° up
C: (Minimum cutoff line height) 3.5 mm (0.138 in) 0.25° down

LOW AND HIGH BEAM

Use adjustment screw to perform aiming adjustment.

  • Ensure fog lamps are turned off.

Block the opposite headlamp from projecting a beam pattern onto the adjustment screen, using a suitable object. Aim each headlamp individually.

Place the screen on the same level and flat surface as the Nissan Murano vehicle.

Face the front of the Nissan Murano vehicle to the screen and measure distance between the headlamp center and the screen surface.

Distance between the headlamp center and the screen (E) : 7.6 m (25 ft)

Start the engine. Turn the headlamp on.

Determine the preferred vertical aim range dimensions, using the aiming chart.

Measure the projected beam within the aim evaluation segment on the screen.

Adjust the beam pattern of each headlamp until the aim evaluation segment (the area relative to both the highest and lowest cutoff line height) is positioned within the vertical aim range dimensions shown on the aiming chart.