Driver Controls

Front Wiper Stop Position Signal Circuit

11steps
~66min
3/5difficulty
Done 0 of 11
Component Function Check

CHECK FRONT WIPER STOP POSITION SIGNAL

CONSULT

  1. Select “WIP AUTO STOP” in “Data Monitor” mode of “IPDM E/R”.

  2. Operate the front wiper.

  3. Check that the function operates normally according to the following conditions:

    Monitor itemConditionMonitor status
    WIP AUTO STOP Front wiper motor Stop position STOP P
    Except stop position ACT P

Is the inspection result normal?

YES>>

Front wiper stop position signal circuit is normal.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK IPDM E/R OUTPUT VOLTAGE

  1. Ignition switch OFF.

  2. Disconnect front wiper motor connector.

  3. Ignition switch ON.

  4. Check voltage between front wiper motor harness connector and ground.

(+)(−)

Voltage

(Approx.)
Front wiper motor
ConnectorTerminal
E23 3 Ground Battery voltage

Is the inspection result normal?

YES>>

Replace front wiper motor. Refer to Removal and Installation.

NO>>

GO TO 2.

CHECK FRONT WIPER STOP POSITION SIGNAL CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect IPDM E/R connector.

  3. Check continuity between IPDM E/R harness connector and front wiper motor harness connector.

    IPDM E/RFront wiper motorContinuity
    ConnectorTerminalConnectorTerminal
    E119 34 E23 3 Yes
  4. Check continuity between IPDM E/R harness connector and ground.

    IPDM E/R—Continuity
    ConnectorTerminal
    E119 34 Ground No

Is the inspection result normal?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Repair or replace harness.