Body Interior

Headlining

~3min read
Exploded View

WITH PANORAMIC ROOF GLASS

1. Headlining 2. Assist grip (without coat hanger) 3. Sun visor holder (LH/RH)
4. Sun visor (RH) 5. Sun visor cover (LH/RH) 6. Sun visor (LH)
7. Front room/map lamp assembly 8. Rear seat belt center retractor finisher 9. Assist grip (with coat hanger)
10. Personal lamp 2nd row (LH) 11. Personal lamp 2nd row (RH) Pawl
Front Clip Metal clip

WITHOUT PANORAMIC ROOF GLASS

1. Headlining 2. Assist grip (without coat hanger) 3. Sun visor holder (LH/RH)
4. Sun visor (RH) 5. Sun visor cover (LH/RH) 6. Sun visor (LH)
7. Front room/map lamp assembly 8. Rear seat belt center retractor finisher 9. Assist grip (with coat hanger)
10. Personal lamp 2nd row (LH) 11. Personal lamp 2nd row (RH) Pawl
Front Clip Metal clip
Removal and Installation

REMOVAL

Remove sun visor cover (LH/RH) (1) by inserting a suitable tool (A) as shown.

: Pawl

Remove sun visor bolts (A) (LH/RH) then disconnect harness connectors and remove .

Insert a suitable tool (A) at approximately a 30 degree angle into sun visor holder notch on front of sun visor holder (1). Press in to release locking tab (B). While holding in locking tab (B), turn sun visor holder (1) 90 degrees to release it from headliner.

  • If sun visor holder (1) does not fully rotate, make sure that suitable tool (A) is pressing in on locking tab (B) and is not positioned under locking tab (B). Reinsert suitable tool (A) as necessary to release locking tab (B).

  • : Front

Disconnect the harness connector from the inside mirror.

Remove front assist grip (LH/RH) and rear assist grip (LH/RH).

Remove assist grip cap (3). Release clip (1) and remove assist grip (2).

Remove front pillar finisher (LH/RH). Refer to Removal and Installation.

Remove center pillar upper finisher (LH/RH). Refer to Removal and Installation.

Remove luggage side upper finisher (LH/RH). Refer to Removal and Installation.

Release clips using a suitable tool and remove rear seat belt center retractor finisher. Refer to Exploded View.

Disconnect harness connectors from headlining.

Using a suitable tool release headlining rear clips and remove headlining through back door.

INSTALLATION

Installation is in the reverse order of removal.