Driver Information & Multimedia
Seat Belt Warning
In this manual: Driver Information & Multimedia
2steps
~12min
3/5difficulty
Done 0 of 2
SYSTEM DIAGRAM

Front Seat Belts
If all of the following conditions are fulfilled:
| Operation conditions | |
|---|---|
| Ignition switch | ON |
| Nissan Murano Vehicle speed | Approximately 15 km/h or more. |
| Front seat belt buckle switch LH | Unfastened (front seat belt buckle switch LH ON) |
| Front seat belt buckle switch RH | Front passenger seat is occupied, seat belt unfastened (front seat belt buckle switch RH ON). |
Rear Seat Belts
If all of the following conditions are fulfilled:
| Operation conditions | |
|---|---|
| Ignition switch | ON |
| Nissan Murano Vehicle speed | Approximately 15 km/h or more. |
| Rear seat belt | When any rear seat belt changes from fastened to unfastened. |
Front Seat Belts
Warning is canceled if any of the following conditions are fulfilled:
| Operation conditions | |
|---|---|
| Ignition switch | OFF |
| Shift selector | Shift position is in P. |
| Front seat belt buckle switch LH | Fastened (front seat belt buckle switch LH OFF) |
| Front seat belt buckle switch RH | Front passenger seat is unoccupied or seat belt fastened (front seat belt buckle switch RH OFF) |
| 90 seconds after the start of warning sound. | |
Rear Seat Belts
If any of the following conditions are fulfilled:
| Operation conditions | |
|---|---|
| Ignition switch | OFF |
| Rear seat belt | When any rear seat belt changes from unfastened to fastened. |
SIGNAL PATH
BCM requires warning chime output to combination meter, when it judges seat belt warning chime is necessary from signals below:
Signal name Signal source Ignition switch ON Front seat belt buckle switch LH/RH signal Front seat belt buckle switch LH/RH
Combination meter
BCMRear seat belt buckle switch LH signal
Rear seat belt buckle switch RH signal
Rear seat belt buckle switch center signal
Rear seat belt buckle switch RH, LH or center
Air bag diagnosis sensor unit
Combination meterCombination meter sounds integrated buzzer, following the warning chime output requirement (below signal) from BCM:
Signal name Signal source Buzzer output signal BCM
Combination meter
Was this page helpful?