Rear floor extension

INTRODUCTION

Replacing this part is an additional operation, for a rear impact, when replacing:

• the rear apron,

• the rear end half crossmember.

IMPORTANT: the separation operation must be carried out last, once all other joints of the part have been released, so that the part can be moved to separate it.

In the operation described below, you will only find descriptions of the joints specific to the part concerned.

Joints associated with additional parts are not covered here. These are covered in their respective chapter (refer to the contents).

M.P.R. PART COMPOSITION

Part assembled with:

• sealing profile,

• striker reinforcement,

• tie-down ring plate.

PARTS CONCERNED (thickness in mm):

1. 1

   Rear floor extension 0.8

2. 2

   Rear floor, rear section 1

3. 3

   Rear end cross member 1.2

4. 4

   Lower light support gusset 1

5. 5

   Side panel gutter, lamp bracket 1.5

6. 6

   Side lining extension 0.8

7. 7

   Lower centre extension 1

8. 8

   Side crossmember 1

9. 9

   Sealing profile 1

   

H = two hexagonal bolts Ø 8 mm