Rear end half crossmember

INTRODUCTION

Replacing this part is an additional operation to replacing the rear apron.

It can be carried out in two ways:

Cut 1 order a right or left half crossmember,
Cut 2 order both half crossmembers then join them at (A) or (B).

For this operation, the use of the repair jig is essential.

The separation operation must be carried out last, once all other joints have been released.

In the operation described below, you will only find descriptions of the joints specific to the part concerned.

Joints associated with additional parts are not covered here. These are covered in their respective chapter (refer to the contents).

M.P.R. PART COMPOSITION

Part assembled with:

• rear end cross member,

• lower centre extension,

• striker plate support absorber,

• lower side extension,

• side crossmember,

• side crossmember reinforcement,

• striker absorber.

PARTS CONCERNED (thickness in mm):

1. 1

   Side panel gutter, lamp bracket 1.5

2. 2

   Lower light bracket gusset 1

3. 3

   Side crossmember reinforcement 1

4. 4

   Rear end cross member 1.2

5. 5

   Side crossmember 1

6. 6

   Side panel extension 1

7. 7

   Rear floor extension 0.8

8. 8

   Lower centre extension 1

9. 9

   Basic body rear apron 1

REPLACEMENT SPECIFICS FOR CUT 1

J = two hexagonal bolts Ø 8 mm

REPLACEMENT SPECIFICS FOR CUT 2

L = two hexagonal bolts Ø 8 mm