Side panel inner panel

INTRODUCTION

Replacing this part is an additional operation to the wing panel or side panel for a rear side impact.

It also requires replacing the centre pillar reinforcement, door pillar, which must be ordered separately.

In the operation described below, you will only find descriptions of the joints specific to the part concerned.

Information on other parts is covered in their respective sections.

This part is replaced in three ways (see sections in the drawing below):

1. 1

   - complete

2. 2

   - partial, section A-A

3. 3

   - partial, section B-B for glazed version

PART COMPOSITION M.P.R.

Part assembled with welded nuts.

LIST OF LINKS:

Upper door pillar or centre pillar reinforcement
Roof rail lining
Side panel gutter, lamp bracket
Rocker closing panel
Rocker closing panel, rear section
Rear wheel arch
Rear end cross member

PARTS CONCERNED (thickness in mm):

1. 1

   Rear quarter panel inner 0.7

2. 2

   Cross member inner panel 0.7

3. 3

   Side panel gutter, tail light bracket 1.2

4. 4

   Rear quarter panel extension 1

5. 5

   Side panel gutter upper reinforcement 1.2

6. 6

   Rocker closing panel 1.5

7. 7

   Rear section sill closing panel 1.5

8. 8

   Upper door sill reinforcement 1.2

9. 9

   Lower door pillar reinforcement 1.2

10. 10

    Seat belt retractor mounting reinforcement 1.5

11. 11

    Inner wheel arch 1

12. 12

    Seat mounting reinforcement 1.5

13. 13

    Rear end cross member 1.2

1 - COMPLETE

2 - PARTIAL, SECTION A-A

2 - PARTIAL, SECTION B-B