Renault Megane Quiz
Trim and upholstery

Seat slides

In this manual: Trim and upholstery
Engine and peripherals — 141Chassis — 79Chassis — 72Renault Mégane III Driver's Manual — 87Electrical equipment — 221Engine and peripherals — 47Electrical equipment — 80Transmission — 14Air conditioning — 30Bodywork — 115Trim and upholstery — 44General vehicle information — 27Air conditioning — 59General vehicle information — 16Transmission — 38Sealing and soundproofing — 7General vehicle information — 3
~1min read

TIGHTENING TORQUES (in N.m)
Seat bolt 35
Frame-to-slide screws 21
IMPORTANT:

Before working on the airbag system, lock the electronic control unit using the diagnostic tools (see chapter 8).

WARNING:

It is forbidden to handle pyrotechnic systems (pretensioners or airbags) near a heat source or flame, as this risks accidental deployment.

REMOVAL

Protect:

  • the front sill trim,
  • the carpet.
Glissières de siège

Unhook the seat belt by pressing the latch (A).

Glissières de siège

Move the seat to the forward position.

Remove the rear mounting bolts.

Mettre le siège en position arrière.

Move the seat to the rear position.

Remove the front mounting bolts.

Glissières de siège

Disconnect the under-seat connector.

Remove the seat.

This procedure requires two operators.

Glissières de siège

Remove the two nuts (B).

Glissières de siège

Remove the three nuts (C).

INSTALLATION

Refit in the reverse order of removal.

CAUTION: Observe the seat bolt tightening sequence.

  • the rear bolt (A) toward the inside of the vehicle,
  • the front bolt (B) toward the inside of the vehicle,
  • the rear bolt (C) toward the outside of the vehicle,
  • the front bolt (D) toward the outside of the vehicle.
Glissières de siège

Tighten to torque.

Test yourself

A quick Renault Megane quiz: every answer comes with an explanation and a link to the manual page.