Flywheel

REMOVAL

• Remove:

• the gearbox (Chapter Manual Gearbox, Manual Gearbox: Removal - Refitting, page 21A-11),
• the clutch mechanism (Chapter Clutch, Clutch Mechanism - Clutch Disc, page 20A-3).

K4J or K4M or K9K

• Fit tool (Mot. 582-01) (8).
• Remove:

• the flywheel bolts,
• the flywheel,
• tool (Mot. 582-01) (8).

F4R or F9Q

• Fit tool (Mot. 1677) (9).
• Remove:

• the flywheel mounting bolts,
• the flywheel,
• tool (Mot. 1677) (9).

Note: The flywheel is a dual-mass flywheel type.

INSTALLATION

• Clean the threads of the flywheel mounting bolts on the crankshaft.
• Degrease the flywheel bearing face on the crankshaft.
• Check the condition of the flywheel.

K9K

Do not remove the flywheel drive plate mounting bolts (10).

• Refit the spacer (11), observing the fitting direction of the chamfer on the flywheel side.
• Always replace the mounting bolts with new bolts.
• Coat the new flywheel bolts with LOCTITE FRENETANCH.

• Tighten in the following order and to the following torques:

• flywheel mounting bolts (K engines) (6.5 daN.m),
• flywheel mounting bolts (F4R engine) (7 daN.m),
• flywheel mounting bolts (F9Q engine) (9 daN.m).