Hyundai Sonata LF Quiz
Body (Interior and Exterior)

Front Seat Belt Pretensioner Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 90Engine Electrical System — 58Emission Control System — 24Engine Control System/Fuel System — 114Drive Shaft and Axle — 15Suspension System — 35Steering — 19Restraints — 50Brake System — 54Body (Interior and Exterior) — 213Body Electrical System — 241Heating, Ventilation, and Air Conditioning — 56DCT (Dual Clutch Transmission) System — 52
5steps
~30min
2/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Replacement
  • When installing the seat belt, take care not to damage the pretensioner.
  1. Remove the lower center pillar trim. (Refer to Interior Trim - "Center Pillar Trim")
  2. Remove the center pillar upper garnish. (Refer to Body Trim - "Center Pillar Garnish")
  3. After loosening the mounting bolt, remove the front seat belt upper anchor (A).

    Tightening torque: 39.2 ~ 54 N·m

  4. After disconnecting the connectors (A) by pressing the lock pin, loosen the mounting bolts, then remove the front seat belt retractor (B).

    Tightening torque: 39.2 ~ 54 N·m

  5. Install in the reverse order of removal.
    • Make sure the connector is properly connected.
    • Replace all damaged clips.

Test yourself

A quick Hyundai Sonata LF quiz: every answer comes with an explanation and a link to the manual page.