Hyundai Sonata LF Quiz
Body (Interior and Exterior)

Outside Rear View Mirror Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 90Engine Electrical System — 58Emission Control System — 24Engine Control System/Fuel System — 114Drive Shaft and Axle — 15Suspension System — 35Steering — 19Restraints — 50Brake System — 54Body (Interior and Exterior) — 213Body Electrical System — 241Heating, Ventilation, and Air Conditioning — 56DCT (Dual Clutch Transmission) System — 52
5steps
~30min
2/5difficulty
0102030405010.88N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Replacement
  • Wear gloves to protect your hands.
  • When prying with a flat-tip screwdriver or a trim tool, wrap the tool with protective tape and apply protective tape to the surrounding parts to prevent damage.
  • Be careful not to scratch the body surface.
  1. After loosening the retaining clips, remove the front door inside quadrant cover (A).
  2. Remove the front door trim. (Refer to Front Door - "Front Door Trim")
  3. Disconnect the outside rear view mirror connector (A).
  4. Loosen the mounting nuts, then remove the outside rearview mirror (B).

    Tightening torque: 6.9 ~ 10.8 N·m

  5. Install in the reverse order of removal.
    • Make sure the connector is properly connected.
    • Replace all damaged clips.

Test yourself

A quick Hyundai Sonata LF quiz: every answer comes with an explanation and a link to the manual page.