Fuel level gauge inspection

Inspect the fuel level gauge in the following procedures:

1. 1
   remove the fuel pump. Refer to “fuel pump disassembly and assembly” in section 1g .
2. 2
   Measure the resistance at each fuel level gauge in float position. If the resistance is incorrect, replace fuel level gauge with a new one.

Special tool : 09900–25008 (multi circuit tester
set)

186.5 ± 5 Mm (3.34 ± 0.2 In) 59.7 ± 5 Mm (2.35 ± 0.2 In)

3. Install the fuel pump. Refer to “fuel pump disassembly and assembly” in section 1g .

If the speedometer, odometer or tripmeter does not function properly, inspect the speed sensor and the coupler connections. If the speed sensor and coupler connections are ok, replace the combination meter unit with a new one. Refer to “combination meter removal and installation” .