Oil pressure switch inspection

Inspect the oil pressure switch in the following procedures:

before inspecting the oil pressure switch, check if the engine oil level is correct. Refer to “engine oil and filter replacement” in section 0b .

1. 1
   Remove the left side cowling. Refer to “exterior parts removal and installation” in section 9d .
2. 2
   Disconnect the oil pressure switch lead wire from the oil pressure switch.
3. 3
   Inspect the oil pressure switch for continuity with the tester. If any abnormality is found, replace the oil pressure switch with a new one.

Special tool : 09900–25008 (multi circuit tester
set)

Tester knob indication continuity ( )

4. After finishing the oil pressure switch inspection, reinstall the removed parts.