Combination meter inspection

Check that the leds “a” (fi, fuel, engine rpm, oil pressure/engine coolant, immobilizer (e-02, 19, 24, 51) and meter panel illumination) immediately light up when the ignition switch is turned on.

Check that the other leds “b” (neutral, high-beam and turn signal indicator lights) light up/go off by operating each switch.

If abnormal condition is found, replace the combination meter assembly with a new one after checking its wire harness/coupler. Refer to “combination meter removal and installation” .

1. Check that the pointers calibrate immediately after turning the ignition switch on and stop at zero point.

   If abnormal condition is found, replace the combination meter assembly with a new one after checking its wire harness/coupler.

• the pointers may not return to the proper position even turning the ignition switch on under low temperature condition. In that case, you can reset the pointers to the proper position by the following instruction.
• Complete the operation within 10 seconds after the ignition switch has been turned on.

1. 1
   With the adj button (1) pressed, turn the ignition switch on.
2. 2
   Keep pushing the adj button for more than 3 to 5 sec.

   

4. Release the adj button, then tap it twice.

Pointers will return to the proper position right after the completion of the operation. In the case of the pointers not returning to the proper position after doing above, replace the combination meter unit.

Refer to “combination meter removal and installation” .