Headlight removal and installation

1. 1
   Remove the body cowling assembly. Refer to “exterior parts removal and installation” in section 9d .
2. 2
   Remove the air intake pipes (1). Refer to “exterior parts removal and installation” in section 9d .
3. 3
   Remove the wiring harness no. 2 (2) By disconnecting the couplers and clamps.

   

4. Remove the intake pipe covers (3).

1. 1
   Remove the intake cover (4).
2. 2
   Remove the body cowling (5).

   

Velcro fastening

Installation is in the reverse order of removal. Pay attention to the following point:

• route the wiring harness properly. Refer to “wiring harness routing diagram” in section 9a .
• After installing, be sure to inspect the headlight beam.

  Refer to “headlight beam adjustment” .