Rear combination light removal and installation

1. 1
   Remove the frame cover assembly. Refer to “exterior parts removal and installation” in section 9d .
2. 2
   Remove the clamps (1).
3. 3
   Disconnect the combination light coupler (2).
4. 4
   Remove the rear combination light assembly (3).

   

5. Remove the combination light bracket (4).

Install the rear combination light in the reverse order of removal. Pay attention to the following point:

• tighten the combination light mounting bolts (1) to the specified torque.

when reusing the removed bolts (1), apply a small quantity of the thread lock to them.

: Thread lock cement
99000–32110 (thread lock cement super “1322” or equivalent)

if led operation is abnormal, replace the rear combination light with a new one.