Starter motor removal and installation

1. 1
   Turn the ignition switch off and disconnect the battery (–) lead wire (1).
2. 2
   Lift and support the fuel tank. Refer to “fuel tank removal and installation” in section 1g (page 1g- 9).
3. 3
   Disconnect the starter motor lead wire (2).
4. 4
   Remove the starter motor (3).

   

Install the starter motor in the reverse order of removal.

Pay attention to the following points:

• apply grease to the o-ring.

: Grease 99000–25010 (suzuki
super grease “a” or equivalent)

Caution replace the o-ring with a new one.

Install the starter motor. Refer to “wiring harness routing diagram” in section 9a .