How To Proceed With Troubleshooting

HINT:

• Use the following procedures to troubleshoot the steering lock system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT

1. INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

NEXT

1. CHECK DTC*

(a) Check for DTCs and make a note of any codes that are output (See page ).

(b) Clear the DTCs (See page ).

(c) Recheck for DTCs (See page ). Based on the
DTCs output above, try to cause the output of the same wireless door lock control system DTC, LIN communication system DTC, steering lock system DTC, engine immobiliser system DTC or smart key system (for entry function) DTC by reproducing the symptoms indicated by the DTC.

B

GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

C

GO TO LIN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

D

GO TO DIAGNOSTIC TROUBLE CODE CHART

E

GO TO ENGINE IMMOBILISER SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

F

GO TO SMART KEY SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

A

1. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table (See page
).

B

GO TO STEP 6

A

1. OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Terminals of ECU (See page ).

(b) Data List / Active Test (See page ).

NEXT

1. REPAIR OR REPLACE

NEXT

1. CONFIRMATION TEST

NEXT

END