How To Proceed With Troubleshooting

HINT:

• Use the following procedures to troubleshoot the seat belt warning system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT

1. INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT

1. CHECK FOR DTC*

(a) Check for DTCs and make a note of any codes that are output.

(b) Clear the DTCs.

(c) Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same CAN communication system DTC, airbag system DTC or occupant classification system DTC by simulating the symptoms indicated by the DTC.

B

GO TO CAN COMMUNICATION SYSTEM

C

GO TO AIRBAG SYSTEM

D

GO TO OCCUPANT CLASSIFICATION SYSTEM

A

1. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table (See page
).

NEXT

1. OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Operation Check (See page ).

(b) Data List / Active Test (See page ).

(c) Terminals of ECU (See page ).

NEXT

1. REPAIR OR REPLACE

NEXT

1. CONFIRMATION TEST

NEXT

END