Inspection

1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Front Wiper Switch Tester Connection Switch Condition Specified Condition A-1 (+S) - A-3 (+1) Off Below 1 Ω INT A-2 (+B) - A-3 (+1) MIST LO A-2 (+B) - A-4 (+2) HI Front Washer Switch Tester Connection Switch Condition Specified Condition B-2 (EW) - B-3 (WF) On Below 1 Ω Off 10 kΩ or higher Rear Wiper Switch Tester Connection Switch Condition Specified Condition B-6 (C1R) - B-2 (EW) Off 10 kΩ or higher B-7 (+1R) - B-2 (EW) B-6 (C1R) - B-2 (EW) INT Below 1 Ω B-7 (+1R) - B-2 (EW) HI Below 1 Ω Rear Washer Switch Tester Connection Switch Condition Specified Condition A-5 (WR) - B-2 (EW) Off 10 kΩ or higher B-7 (+1R) - B-2 (EW) A-5 (WR) - B-2 (EW) WASH Below 1 Ω A-5 (WR) - B-2 (EW) On + WASH Below 1 Ω B-7 (+1R) - B-2 (EW) If the result is not as specified, replace the windshield wiper switch assembly. Text in Illustration *a Component without harness connected (Windshield Wiper Switch Assembly)

(b) Check the intermittent operation.

1. 1
   Connect the positive (+) lead of a voltmeter to terminal A-3 (+1) and the negative (-) lead to terminal B-2 (EW).
2. 2
   Connect the positive (+) lead of the battery to terminal A-2 (+B) and the negative (-) lead to terminal B-2 (EW) and A-1 (+S).
3. 3
   Turn the wiper switch to the INT position.
4. 4
   Connect the positive (+) lead of the battery to terminal A-1 (+S) for 5 seconds.
5. 5
   Connect the negative (-) lead of the battery to terminal A-1 (+S). Operate the intermittent wiper relay and check the voltage between terminals A-3 (+1) and B-2 (EW).

   OK:

   Voltage changes as shown in the illustration.

   
   

   If the result is not as specified, replace the windshield wiper switch assembly.

   Text in Illustration

   *1	Voltage between terminals A-3 (+1) and B-2 (EW)	*2	FAST: Negative lead of battery connected to terminal A-1 (+S)
   *3	SLOW: Negative lead of battery connected to terminal A-1 (+S)	-	-