Installation

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the switch to the manual valve shaft.

(b) Temporarily install the bolt.

(c) Install a new lock washer and the nut.

Torque:

6,9 N·m {70 kgf·cm, 61 in·lbf}

(d) Turn the control shaft lever LH clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.

(e) Align the neutral basic line with the switch groove. Text in Illustration *1 Neutral Basic Line *2 Groove

(f) Hold the switch in position and tighten the bolt.

Torque:

13 N·m {130 kgf·cm, 9 ft·lbf}

(g) Using a screwdriver, bend the tabs of the lock washer.

(h) Connect the switch connector.

2. INSPECT SHIFT LEVER POSITION

3. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY