Installation

1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

(a) Remove any dust and oil from the differential carrier assembly and the contact surfaces of the axle housing.

(b) Install a new gasket and the differential carrier assembly with the 11 nuts and 11 washers.

Torque:

52 N·m {530 kgf·cm, 38 ft·lbf}

(c) Connect the differential lock actuator connector.

(d) Connect the rear differential lock actuator breather hose to the differential actuator assembly.

2. INSTALL REAR AXLE SHAFT LH

(a) Install the rear axle shaft LH (See page
).

3. INSTALL REAR AXLE SHAFT RH

HINT:

Use the same procedure described for the LH side.

4. INSTALL PROPELLER SHAFT ASSEMBLY

(a) Install the propeller shaft assembly (See page ).