Seat Belt

Tongue Stopper

~2min read

Components

COMPONENTS

ILLUSTRATION

*1

TONGUE STOPPER

-

-

●

Non-reusable part

-

-

Replacement

REPLACEMENT

PROCEDURE

1. REMOVE TONGUE STOPPER

(a) Slide the tongue above the tongue stopper installation position and temporarily hold it in place with adhesive tape.

*a

Tape

*b

Tongue

*c

Broken tongue stopper

(b) Using pliers, remove any original tongue stopper parts from the seat belt webbing.

NOTICE:

Be careful not to damage the seat belt webbing during the repair.

2. INSTALL TONGUE STOPPER

(a) Place a new tongue stopper into the hole in the seat belt webbing.

HINT:

Make sure the tongue stopper is installed in the direction shown in the illustration.

*1

Tongue Stopper

*a

Male

*b

Female

*c

Seat Belt Webbing

(b) Hold the tongue stopper in the hole in the seat belt webbing using an adjustable wrench, and turn the adjusting screw of the adjustable wrench by hand to compress the tongue stopper.

NOTICE:

  • When using the adjustable wrench, make sure the male and female parts of the tongue stopper are parallel to each other.
  • Do not use pliers to compress the tongue stopper pin. It may damage the tongue stopper and seat belt webbing.

HINT:

Wrap the jaws of the adjustable wrench before use.

*a

Protective tape

(c) When the adjusting screw of the adjustable wrench can no longer be turned by hand, tighten the adjusting screw using slip joint pliers until the thickness of the tongue stopper is 4.5 to 5.0 mm (0.177 to 0.197 in.). (See illustration)

Standard clearance

Area

Measurement

a

4.5 to 5.0 mm (0.177 to 0.197 in.)

(d) Make sure the pin on the male side of the tongue stopper has spread evenly in the female part hole and is securely held to the seat belt webbing. (See illustration)

*a

Correct

*b

Incorrect