Seat Heater Switch
Components
COMPONENTS
ILLUSTRATION
*1 |
SEAT HEATER SWITCH SUBASSEMBLY |
- |
- |
Removal
REMOVAL
PRECAUTION / NOTICE / HINT
Necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during seat heater switch subassembly removal/installation are shown below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Required Procedure | Effect/Inoperative function when procedure not performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
CAUTION:
- Be sure to read the Precautions carefully before performing maintenance.
Click here
.gif)
- Wear protective gloves. Sharp edges on parts may cause injury to your hands.
HINT:
- Perform the same procedure for the driver side and front passenger side.
- The procedure below applies to the driver side.
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY
Click here![]()
2. REMOVE SEAT HEATER SWITCH SUBASSEMBLY
(a) Release the claw to detach the seat heater switch subassembly. |
![]() |
(b) Disconnect the connector to remove the seat heater control subassembly. |
![]() |
Installation
INSTALLATION
PRECAUTION / NOTICE / HINT
CAUTION:
- Be sure to read the Precautions carefully before performing maintenance.
Click here
.gif)
- Wear protective gloves. Sharp edges on parts may cause injury to your hands.
HINT:
- Perform the same procedure for the driver side and front passenger side.
- The procedure below applies to the driver side.
PROCEDURE
1. INSTALL SEAT HEATER CONTROL SUBASSEMBLY
(a) Connect the connector.
(b) Engage the claw to install the seat heater control subassembly. |
![]() |
2. INSTALL FRONT SEAT ASSEMBLY
Click here![]()


.png)