Power Seat Control System
Component Locations
COMPONENT LOCATIONS
ILLUSTRATION
*1 |
INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - FUSE P/SEAT |
- |
- |
ILLUSTRATION
*1 |
LEFT LUMBAR SUPPORT ADJUSTER ASSEMBLY |
*2 |
FRONT POWER SEAT LUMBAR SUPPORT SWITCH |
System Diagram
SYSTEM DIAGRAM
Operation Check
OPERATION CHECK
INSPECT POWER SEAT OPERATION
(a) Check basic functions.
*a |
Lumbar Support Adjustment Function |
(1) Operate the front power seat lumbar support switch and check that the lumbar support adjustment function operates:
INSPECT LUMBAR SUPPORT ADJUSTER MOTOR
(a) Check the operation of the PTC inside the lumbar support adjuster motor.
NOTICE:
Perform the check with the seat installed in the vehicle.
(1) Operate the front power seat lumbar support switch and move the lumbar support to the most forward or most rearward position. Hold the seat in this position for approximately 60 seconds.
(2) Operate the front power seat lumbar support switch again and keep trying to move the lumbar support in the same direction as in the previous step. Measure the time elapsed from when the power is cut off (motor operating noise stops).
Standard:
4 to 90 seconds
(3) Once the power is cut off, release the front power seat lumbar support switch and wait approximately 60 seconds.
(4) Operate the front power seat lumbar support switch and move the lumbar support in the opposite direction. Make sure the motor operates.
Symptom Table
SYMPTOM TROUBLESHOOTING TABLE
HINT:
- Use the table below to determine the cause of the symptoms. If several suspected areas are listed, the possible causes of the symptom are shown in order of probability in the "Suspected Area" column of the table. Check each symptom, verifying the suspected areas in the order listed. Replace parts if necessary.
- Check the fuses and relays associated with this system before checking the suspected areas listed below.
Symptom | Suspected Area | Link |
|---|---|---|
Lumbar support adjustment function does not operate |
Front Power Seat Lumbar Support Switch |
|
Left Lumbar Support Adjuster Assembly |
||
Wire harness or connector |
- |
.gif)