Parking Assist / Monitor System

Removal

~1min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed or replaced during blind spot monitor sensor removal/installation are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Blind Spot Monitor Sensor Replacement

Blind Spot Monitor Beam Axis Adjustment

DTCs are output

PROCEDURE

1. REMOVE REAR BUMPER ASSY

Click here

2. REMOVE LEFT BLIND SPOT MONITOR SENSOR

(a) Disconnect the connector.

(b) Remove the 3 nuts and the left blind spot monitor sensor.

NOTICE:

Replace the left blind spot monitor sensor if it has been dropped or has received a strong impact.

3. REMOVE RIGHT BLIND SPOT MONITOR SENSOR

HINT:

Perform the same procedure as for the left side.

4. REMOVE LEFT BLIND SPOT MONITOR BRACKET

(a) Remove the 3 nuts and the left blind spot monitor bracket.

5. REMOVE RIGHT BLIND SPOT MONITOR BRACKET

HINT:

Perform the same procedure as for the left side.