Parking Assist / Monitor System

Installation

~2min read
3special tools
01020304050107N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

NOTICE:

  • Avoid any impact to the blind spot monitor sensor.
  • Do not drop the left blind spot monitor sensor. If the sensor is dropped, replace it with a new one.

HINT:

  • The blind spot monitor beam axis check is performed to verify whether the sensor transmits radio waves.
  • The blind spot monitor beam axis confirmation is performed to verify whether the sensor beam axis is correct, and to adjust the beam axis using the reflector.
  • The blind spot monitor sensor installation condition check is performed to verify, using a gauge, whether the sensor is perpendicular to the ground (+/-5°), and whether the sensor is 16 to 24° from the line parallel to the vehicle centerline.

PROCEDURE

1. INSTALL LEFT BLIND SPOT MONITOR BRACKET

(a) Install the left blind spot monitor sensor bracket using the 3 nuts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

2. INSTALL RIGHT BLIND SPOT MONITOR BRACKET

HINT:

Perform the same procedure as for the left side.

3. INSTALL LEFT BLIND SPOT MONITOR SENSOR

(a) Connect the connector.

(b) Install the left blind spot monitor using the 3 nuts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

4. INSTALL RIGHT BLIND SPOT MONITOR SENSOR

HINT:

Perform the same procedure as for the left side.

5. PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION CHECK

Click here

6. INSTALL REAR BUMPER ASSY

Click here

7. CONFIRM BLIND SPOT MONITOR BEAM AXIS

Click here

SST: 09870-60000

09870-60010

SST: 09870-60040

8. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here