Audio / Video

Removal

~1min read

REMOVAL

PRECAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side as for the LH side.
  • The procedure described below applies to the LH side.

PROCEDURE

1. REMOVE REAR DOOR INSIDE HANDLE GARNISH CLIP

Click here

2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL

Click here

3. REMOVE REAR DOOR REAR FRAME BRACKET

Click here

4. REMOVE REAR DOOR TRIM PANEL SUBASSEMBLY

Click here

5. REMOVE REAR SPEAKER ASSEMBLY

(a) Disconnect the connector.

(b) Using a drill with a bit smaller than 5 mm (0.197 in.) in diameter, drill 3 rivet heads.

NOTICE:

  • Do not touch the speaker cone.
  • Do not drill the rivet at an angle as this may damage the drill and the rivet hole. Align the drill with the rivet, then carefully drill the rivet head.
  • Be careful as the drilled rivet is hot.

(c) Continue drilling and push out the remaining rivet fragments.

(d) Using a vacuum cleaner, remove the rivet fragments and shavings from inside the door.

(e) Release the claw and guide to remove the rear speaker assembly.