Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during steering wheel switch assembly removal/installation are shown below.
Procedures Required After Replacement / Removal / Installation of Parts: Engine Start and Stop SystemReplaced Part or Performed Procedure | Required Procedure | Effect/Inoperative Function When Required Procedure Is Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
PROCEDURE
1. REMOVE HORN BUTTON ASSEMBLY
Click here
![]()
2. REMOVE STEERING WHEEL SWITCH ASSEMBLY
(a) Disconnect the connector from the spiral cable with sensor assembly. |
![]() |
(b) Remove the 2 screws. |
![]() |
(c) Release the 4 claws and 4 pins to remove the steering wheel switch assembly.
.gif)

