Removal
REMOVAL
PRECAUTION / NOTICE / HINT
HINT:
- Repeat the same procedure for the right side and the left side.
- The following procedure applies to the left side.
PROCEDURE
1. REMOVE OUTSIDE REAR VIEW MIRROR
(a) Apply protective tape to the area shown in the illustration.
![]() |
Protective tape |
![]() |
Remove in this direction |
(b) Push the upper part of the mirror surface and tilt it.
(c) Using a moulding remover A, release the claws at the lower part of the outside rear view mirror as shown in the illustration.
NOTICE:
Do not push the outside rear view mirror with excessive force. This could cause the actuator to come out or the mirror surface to break.
HINT:
If excessive force is applied when pressing the mirror surface, the claws engage again.
(d) Push the lower part of the mirror surface and tilt it.
HINT:
If excessive force is applied when pressing the mirror surface, the claws engage again.
(e) Using a moulding remover A, release the claws at the upper part of the outside rear view mirror as shown in the illustration.
![]() |
Protective tape |
![]() |
Remove in this direction |
NOTICE:
Do not push the outside rear view mirror with excessive force. This could cause the actuator to come out or the mirror surface to break.
HINT:
If excessive force is applied when pressing the mirror surface, the claws engage again.
(f) With blind spot monitor:
(1) Disconnect the connector. |
![]() |
(g) Disconnect the 2 connectors to remove the outside rear view mirror. |
![]() |
.png)
.png)

