Mirrors (Outer)

Inspection

~2min read

INSPECTION

PROCEDURE

1. INSPECT LH OUTSIDE REAR VIEW MIRROR

(a) Check the resistance.

(1) Measure the resistance according to the value(s) shown in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

1 - 2

25 °C

8,5 à 11,5 Ω

If the result is not as specified, replace the LH outside rear view mirror.

*a

Component without wire harness connected

(LH outside rear view mirror)

(b) Check the operation of the outside rear view mirror indicator. (with blind spot monitor system)

NOTICE:

Do not apply voltage higher than 6 V.

(1) Connect 4 new dry cell batteries (1.5 V) in series.

(2) Apply battery voltage of 6 V to the connector terminals and check that the outside rear view mirror indicator lights up.

OK:

Tester Connection

Specified Condition

Battery positive (+) 6 V → Terminal 1

Battery negative (-) 6 V → Terminal 2

The outside rear view mirror indicator lights up

If the result is not as specified, replace the LH outside rear view mirror.

*a

Component without wire harness connected

(LH outside rear view mirror)

2. INSPECT RH OUTSIDE REAR VIEW MIRROR

(a) Check the resistance.

(1) Measure the resistance according to the value(s) shown in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

1 - 2

25 °C

8,5 à 11,5 Ω

If the result is not as specified, replace the RH outside rear view mirror.

*a

Component without wire harness connected

(RH outside rear view mirror)

(b) Check the operation of the outside rear view mirror indicator. (with blind spot monitor system)

NOTICE:

Do not apply voltage higher than 6 V.

(1) Connect 4 new dry cell batteries (1.5 V) in series.

(2) Apply battery voltage of 6 V to the connector terminals and check that the outside rear view mirror indicator lights up.

OK:

Tester Connection

Specified Condition

Battery positive (+) 6 V → Terminal 1

Battery negative (-) 6 V → Terminal 2

The outside rear view mirror indicator lights up

If the result is not as specified, replace the RH outside rear view mirror.

*a

Component without wire harness connected

(RH outside rear view mirror)