Supplemental Restraint Systems

Removal

~3min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during removal/installation of the instrument panel integrated passenger airbag assembly are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

Initialize Back Door Lock

Door Lock Control System

PROCEDURE

1. PRECAUTIONS

CAUTION:

Be sure to read the Precautions carefully before performing maintenance.

Click here

NOTICE:

After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.

Click here

2. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here

3. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

CAUTION:

When storing the passenger side instrument panel airbag assembly, make sure the airbag deployment side is facing up.

Deployment side

(a) Remove the 2 screws.

(b) Release the hooks to remove the passenger side instrument panel airbag assembly from the instrument panel safety pad sub-assembly.

NOTICE:

Take care not to damage the deployment surface of the passenger side instrument panel airbag assembly.

4. REMOVE NO. 2 INSTRUMENT PANEL WIRE

(a) for single type:

(1) Release the clip.

*a

Protective tape

*b

Airbag connector

*c

Airbag Connector Lock

(2) Using a screwdriver with its tip wrapped in protective tape, unlock the airbag connector lock.

(3) Disconnect the airbag connector to remove the No. 2 instrument panel wire from the passenger side instrument panel airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.

(b) for double type:

(1) Release the clip.

*a

Protective tape

*b

Airbag connector

*c

Airbag Connector Lock

(2) Using a screwdriver with its tip wrapped in protective tape, release the 2 airbag connector locks.

(3) Disconnect the 2 airbag connectors to remove the No. 2 instrument panel wire from the front passenger side instrument panel airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.