Tire Pressure Monitoring

Removal

~1min read

REMOVAL

PRECAUTION / NOTICE / HINT

The required procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed or replaced during removal/installation of the tire pressure monitoring ECU and receiver are shown below.

Replacement part or procedure

Necessary Procedures

Effects / Does not operate after performing

Link

Replacement of Tire Pressure Warning ECU and Receiver

  • Register transmitter ID
  • Initialize the tire pressure warning system
  • When the DTC "transmitter ID not received" detection conditions are met, the TPWS indicator flashes for 1 minute, then remains on.
  • Tire pressure warning function

for registration

for initialization

NOTICE:

When replacing the tire pressure warning ECU and receiver, record the IDs stored in the ECU using the Techstream and note them down before removal.

Click here

PROCEDURE

1. REMOVE LH LUGGAGE COMPARTMENT SIDE TRIM BOARD ASSEMBLY

Click here

2. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:

  • Do not drop, strike or subject the tire pressure warning ECU and receiver to impact.
  • If the tire pressure warning ECU and receiver are subjected to impact, replace them.

(a) Remove the bolt.

(b) Release the 2 guides.

(c) Disconnect the connector to remove the tire pressure warning ECU and receiver.