Tire Pressure Monitoring

Removal

~2min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after the parts have been removed and installed or replaced during removal and installation of the tire pressure warning valve and transmitter are shown below.

Replacement part or procedure

Necessary Procedures

Effects / Does not operate after performing

Link

Replacement of Tire Pressure Warning Valve and Transmitter

  • Register transmitter ID
  • Initialize the tire pressure warning system
  • When the DTC "transmitter ID not received" detection conditions are met, the TPWS indicator flashes for 1 minute, then remains on.
  • Tire pressure warning function

for registration

for initialization

NOTICE:

When replacing the tire pressure warning ECU and receiver, record the IDs stored in the ECU using the Techstream and note them down before removal.

Click here

PROCEDURE

1. REMOVE WHEEL ASSEMBLY

Click here

2. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER

(a) Remove the tire valve cap.

NOTICE:

Keep the removed tire valve cap.

(b) Remove the valve core and release the air from the tire.

NOTICE:

Make sure a sufficient amount of air has been released.

(c) Using an 11 mm socket wrench, remove the nut and washer.

(d) Push the tire pressure warning valve and transmitter with the grommet into the tire.

HINT:

The grommet may remain attached to the wheel rim.

(e) Using a tire changer tool, remove the tire from the wheel rim.

NOTICE:

  • Make sure the tire pressure warning valve and transmitter are not damaged by contact between the valve and the tire bead.
  • Position the tire changer tool jaw as shown in the illustration.

*1

Tire

*a

Shoe

*b

10 to 20 mm (0.394 to 0.787 in.)

(f) Remove the tire pressure warning valve and transmitter with the grommet from the tire.

(g) Remove the grommet from the tire pressure warning valve and transmitter.