Rear Suspension

Removal

2steps
~12min
1/5difficulty
Done 0 of 2

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed once the parts have been removed and installed or replaced during removal/installation of the rear suspension arm assembly are indicated below.

Procedures Required After Replacement / Removal / Installation of Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Rear Wheel Alignment Adjustment

  1. Clear the zero point calibration data.
  2. Perform zero point calibration of the yaw rate and acceleration sensor.
  • DTCs are stored
  • ABS warning light comes on
  • Skid control warning light comes on
  • VSC OFF or malfunctioning

Removal/installation of rear left height control sensor sub-assembly*1

Initialize LH Headlight ECU Sub-assembly

Automatic Headlight Leveling System

Suspension, tires, etc.

(Vehicle height changes due to suspension or tire replacement)*1

  • *1: with height control sensor

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. REMOVE REAR WHEEL

Click here

2. REMOVE REAR LEFT HEIGHT CONTROL SENSOR SUB-ASSEMBLY (with height control sensor)

Click here

3. REMOVE REAR STABILIZER LINK ASSEMBLY

Click here

4. REMOVE REAR COIL SPRING

Click here

5. REMOVE REAR COIL SPRING LOWER INSULATOR

Click here

6. REMOVE REAR SUSPENSION ARM ASSEMBLY NO. 2

(a) Remove the nut, camber adjusting cam no. 2, rear suspension toe adjusting cam sub-assembly and rear suspension arm assembly no. 2.

NOTICE:

Hold the rear suspension toe adjusting cam subassembly while turning the nut.

7. REMOVE REAR SUSPENSION ARM ASSEMBLY NO. 1

(a) Remove the 2 bolts, 2 nuts and rear suspension arm assembly no. 1 from the rear axle carrier sub-assembly and rear suspension member sub-assembly.

NOTICE:

Do not turn the nut as it has a stopper. Loosen the bolt with the nut in place.