Rear Suspension

Removal

2steps
~12min
1/5difficulty
Done 0 of 2

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts have been removed and installed or replaced during rear coil spring removal/installation are shown below.

Procedures Required After Replacement / Removal / Installation of Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Rear Wheel Alignment Adjustment

  1. Clear the zero point calibration data.
  2. Perform zero point calibration of the yaw rate and acceleration sensor.
  • DTCs are stored
  • ABS warning light comes on
  • Skid control warning light comes on
  • VSC OFF or malfunctioning

Removal/installation of rear left height control sensor sub-assembly*1

Initialize LH Headlight ECU Sub-assembly

Automatic Headlight Leveling System

Suspension, tires, etc.

(Vehicle height changes due to suspension or tire replacement)*1

  • *1: with height control sensor

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. REMOVE REAR WHEEL

Click here

2. REMOVE REAR LEFT HEIGHT CONTROL SENSOR SUB-ASSEMBLY (with height control sensor)

Click here

3. REMOVE REAR COIL SPRING

(a) Make alignment marks on the No. 2 camber adjusting cam, the rear suspension toe adjusting cam sub-assembly and the rear suspension member sub-assembly.

*a

Alignment Mark

(b) Loosen the nut (rear suspension member sub-assembly side) of the No. 2 rear suspension arm assembly.

NOTICE:

Hold the rear suspension toe adjusting cam subassembly while turning the nut.

(c) Using a jack and a block of wood, support the No. 2 rear suspension arm assembly.

NOTICE:

  • When jacking up the No. 2 suspension arm assembly, be sure to do so slowly.
  • Be sure to perform this operation with the vehicle lowered as far as possible.

*a

Wooden Block

*b

Jack

(d) Remove the bolt and nut, and disconnect the No. 2 rear suspension arm assembly (rear axle carrier sub-assembly side) from the rear axle carrier sub-assembly.

NOTICE:

Do not turn the nut as it has a stopper. Loosen the bolt with the nut in place.

(e) Slowly lower the No. 2 rear suspension arm assembly, then remove the rear coil spring.

4. REMOVE REAR COIL SPRING UPPER INSULATOR

(a) Remove the rear coil spring upper insulator from the vehicle.

5. REMOVE REAR COIL SPRING LOWER INSULATOR

(a) Remove the rear coil spring lower insulator from the No. 2 rear suspension arm assembly.