Rear Suspension

Installation

~2min read
03060901201507354N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL REAR COIL SPRING UPPER INSULATOR

(a) Install the rear coil spring upper insulator to the vehicle.

2. INSTALL REAR COIL SPRING LOWER INSULATOR

(a) Install the rear coil spring lower insulator to the No. 2 rear suspension arm assembly.

3. INSTALL REAR COIL SPRING

(a) Set the rear coil spring on the No. 2 rear suspension arm assembly.

*a

Identification mark

*b

30° max.

Vehicle inner side

NOTICE:

  • Install the rear coil spring so that its lower end is within the area shown in the illustration.
  • Install the rear coil spring with the identification mark facing as shown in the illustration.

(b) Using a jack and a wooden block, slowly jack up the No. 2 rear suspension arm assembly and install the No. 2 rear suspension arm assembly to the rear axle carrier sub-assembly using the bolt and nut.

  • Do not jack up the vehicle too high.
  • The vehicle may fall and cause a serious accident.

NOTICE:

  • Do not turn the nut as it has a stopper. Tighten the bolt with the nut in place.
  • When jacking up the No. 2 suspension arm assembly, be sure to do so slowly.
  • Be sure to perform this operation with the vehicle lowered as far as possible.
  • Insert the bolt with the threaded portion facing the front of the vehicle.

*a

Wooden Block

*b

Jack

4. STABILIZE SUSPENSION

Click here

5. INSTALL NO. 2 REAR SUSPENSION ARM ASSEMBLY

(a) Install the No. 2 rear suspension arm assembly (rear axle carrier sub-assembly side) with the bolt.

Torque:

73 N·m {744 kgf·cm, 54 ft·lbf}

NOTICE:

Do not turn the nut as it has a stopper. Tighten the bolt with the nut in place.

6. INSTALL REAR LEFT HEIGHT CONTROL SENSOR SUB-ASSEMBLY (with height control sensor)

Click here

7. INSTALL REAR WHEEL

Click here

8. INSTALL NO. 2 REAR SUSPENSION ARM ASSEMBLY

(a) Install the No. 2 rear suspension arm assembly (rear suspension member sub-assembly side) using the nut.

Click here

9. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Click here

10. PERFORM INITIALIZATION (with height control sensor)

Click here