Precautions
PRECAUTION
IGNITION SWITCH TERMS
(a) The type of ignition switch used varies depending on vehicle specifications. The terms listed in the table below are used in this section.
Term | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
Ignition Switch in OFF position |
LOCK |
OFF (Locked) |
Ignition Switch in ACC position |
ACC |
ON (ACC) |
Ignition Switch in ON position |
ON |
ON (IG) |
Starting the engine |
START |
ON (Starting) |
CAUTIONS WHEN HANDLING STEERING SYSTEM
(a) Parts replacement must be performed with care. Improper replacement may affect the performance of the steering system and may create a hazard while driving.
PRECAUTIONS WHEN HANDLING THE SRS AIRBAG SYSTEM
(a) This vehicle is equipped with a Supplemental Restraint System (SRS). Failure to follow the correct order of service operations may cause the SRS to deploy accidentally during servicing, which may result in a serious accident. Before starting any service operation (inspection, replacement, removal and installation of parts), be sure to read the precautions concerning the Supplemental Restraint System carefully.
Click here
![]()
PRECAUTIONS WHEN WORKING ON THE STEERING COLUMN
(a) When handling the steering column assembly:
(1) Do not subject the steering column assembly (especially the motor and torque sensor) to impact. Replace the steering column assembly with a new one if it is subjected to a severe impact.
(2) Do not pull on the wire harness when moving the steering column assembly.
(3) When the power source of the steering column sub-assembly has been replaced, perform calibration of the torque sensor zero point.
Click here![]()
(b) When disconnecting or reconnecting connectors:
(1) Before disconnecting the connectors related to the power steering system, turn the ignition switch to ON, center the steering wheel, turn the ignition switch to OFF, then disconnect the connectors.
(2) Before reconnecting the connectors related to the power steering system, make sure the ignition switch is OFF. Then center the steering wheel and turn the ignition switch to ON.
NOTICE:
Do not turn the ignition switch to ON if the steering wheel is not centered.
(3) If the above operations are not performed correctly, the steering center point (zero point) may deviate from its specified value, which may cause a difference in steering effort between the right and left directions.
If there is a difference in steering effort between the right and left directions, perform calibration of the torque sensor zero point after initializing the torque sensor zero point.
Click here![]()
PRECAUTIONS WHEN HANDLING THE SPIRAL CABLE
(a) Do not replace the spiral cable sub-assembly with sensor when the battery is connected and the ignition switch is ON.
(b) Do not swap the spiral cable sub-assembly with sensor without locking the steering wheel assembly, with the battery connected and the ignition switch ON.
(c) Make sure the steering wheel assembly is installed and aligned with the vehicle's centerline when checking the steering angle sensor.
(d) Make sure the spiral cable sub-assembly with sensor is centered when installing it, and when removing and installing the steering wheel angle of the front wheels.
Click here
![]()
CAUTION:
If the steering wheel is turned without the spiral cable sub-assembly with sensor installed in the centered position, the cable may break.