Electrical Distribution

Installation

~3min read
0102030405086N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NOTICE:

  • Make sure the mating surfaces are free of foreign matter.
  • Do not touch the connector of the main body ECU (multiplex network body ECU).

(a) Place the main body ECU (multiplex network body ECU) where the guide of the main body ECU (multiplex network body ECU) contacts the side of the instrument panel junction block assembly housing, as shown in the illustration.

*a

20° minimum

*b

Housing side

Place in this direction

HINT:

Be sure to maintain an angle of 20° minimum as shown in the illustration.

(b) Slide the main body ECU (multiplex network body ECU) along the housing side as shown in the illustration and engage the guides.

*a

Housing side

slide in this direction

(c) While keeping the main body ECU (multiplex network body ECU) in contact with side A of the instrument panel junction block assembly (rotation axis), lower it as shown in the illustration.

*a

Side A

Install in this direction

(d) Press the pressure area until the claw engages to install the main body ECU (multiplex network body ECU).

*1

Instrument Panel Junction Block Assembly

*2

Main body ECU (multiplex network body ECU)

Pressure Point

NOTICE:

  • Be sure to press only the pressure area.
  • Engagement of the main body ECU (multiplex network body ECU) and the instrument panel junction block assembly is confirmed by the click heard when the lock engages.

HINT:

If no click is heard, visually check that the lock is engaged. Engagement can also be confirmed if the main body ECU (multiplex network body ECU) and the instrument panel junction block assembly are aligned.

(e) Engage the clip to install the wire harness clamp bracket.

(f) Temporarily install the bolt.

HINT:

Do not fully tighten the bolt.

2. INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU

(a) Connect the 2 connectors and raise the lock levers to engage the claws and lock the connector as shown in the illustration.

Install in this direction

NOTICE:

Be sure to connect the connector correctly.

(b) Engage the clip.

(c) Engage the clip.

(d) Engage the clip to install the instrument panel junction block assembly with main body ECU.

(e) Install the bolt and nut.

Torque:

8 N·m {82 kgf·cm, 71 in·lbf}

(f) Tighten the bolt.

Torque:

8 N·m {82 kgf·cm, 71 in·lbf}

(g) Connect the 2 connectors and raise the 2 lock levers to engage the claws and lock the connector as shown in the illustration.

Install in this direction

NOTICE:

Be sure to connect the connector correctly.

(h) Connect the 4 connectors.

(i) Engage the clip.

3. INSTALL INSTRUMENT PANEL AND NO. 3 CANOPY REINFORCEMENT SUB-ASSEMBLY (except cold area specification vehicles)

Click here

4. INSTALL INSTRUMENT PANEL AND NO. 3 CANOPY REINFORCEMENT SUB-ASSEMBLY (for cold area specification vehicles)

Click here

5. INSTALL NO. 1 INSTRUMENT PANEL LOWER AIRBAG ASSEMBLY

Click here

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here