Rear Suspension

Installation

~1min read
03060901201507354N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL REAR UPPER ARM ASSEMBLY LH

(a) Temporarily install the rear upper arm assembly LH to the rear suspension member sub-assembly with the bolt and nut.

NOTICE:

  • Do not turn the nut as it has a stopper. Tighten the bolt with the nut in place.
  • Insert the bolt with the threaded portion facing the front of the vehicle.

(b) Position the rear upper arm assembly LH as shown in the illustration.

Reference length (A):

17.9 mm (0.705 in.)

(c) Fully tighten the bolt.

Torque:

73 N·m {744 kgf·cm, 54 ft·lbf}

NOTICE:

Do not turn the nut as it has a stopper. Tighten the bolt with the nut in place.

2. INSTALL REAR UPPER ARM ASSEMBLY RH

HINT:

Perform the same procedure as for the left side.

3. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

Click here