Rear Suspension

Installation

~2min read
0408012016020012089N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL REAR SUSPENSION ARM BRACKET

(a) Temporarily install the rear suspension arm bracket to the rear trailing arm assembly with the bolt and nut.

NOTICE:

  • Do not turn the bolt as it has a stopper. Tighten the nut with the bolt in place.
  • Insert the bolt from the inside of the vehicle.

(b) Position the rear trailing arm assembly as shown in the illustration.

Reference length (A):

150 mm (5.91 in.)

*a

Top surface of rear suspension arm bracket

*b

Edge of rear trailing arm assembly

(c) Fully tighten the nut.

Torque:

120 N·m {1 224 kgf·cm, 89 ft·lbf}

NOTICE:

Do not turn the bolt as it has a stopper. Tighten the nut with the bolt in place.

2. INSTALL REAR SUSPENSION SUPPORT COVER NO. 1

(a) Engage the 3 claws to install the rear suspension support cover No. 1.

3. INSTALL REAR TRAILING ARM ASSEMBLY

(a) Using a transmission jack and a wooden block, support the No. 2 rear suspension arm assembly.

NOTICE:

  • When jacking up the No. 2 suspension arm assembly, be sure to do so slowly.
  • Be sure to perform this operation with the vehicle lowered as far as possible.

(b) Install the rear trailing arm assembly to the vehicle with the 4 bolts.

Torque:

90 N·m {918 kgf·cm, 66 ft·lbf}

(c) Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts.

Torque:

135 N·m {1 377 kgf·cm, 100 ft·lbf}

4. INSTALL NO. 2 REAR PARKING BRAKE CABLE ASSEMBLY

(a) Engage the clip.

(b) Install the No. 2 parking brake cable assembly and the rear trailing arm assembly using the nut.

Torque:

15.5 N·m {158 kgf·cm, 11 ft·lbf}

(c) Connect the No. 2 parking brake cable connector to the rear axle hub and bearing assembly.

5. INSTALL REAR STABILIZER BAR LINK ASSEMBLY

Click here

6. INSTALL REAR WHEEL

Click here

7. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Click here