Parking Brake System
Precautions
PRECAUTION
IGNITION SWITCH TERMS
(a) The type of ignition switch used varies depending on vehicle specifications. The terms listed in the table below are used in this section.
Term | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
Ignition Switch in OFF position |
LOCK |
OFF (Locked) |
Ignition Switch in ACC position |
ACC |
ON (ACC) |
Ignition Switch in ON position |
ON |
ON (IG) |
Starting the engine |
START |
ON (Starting) |
NOTICE:
- If the battery is connected, the parking brake operates when the electric parking brake switch assembly is pulled toward the lock side, even if the engine switch is in the OFF position. Do not operate the electric parking brake switch assembly with the battery connected unless instructed otherwise in the repair manual.
- To prevent the electric parking brake system from operating when the shift lever is moved, make sure the AUTO function (shift-linked function) is turned off.
Click here
.gif)
- The parking brake ECU assembly (brake actuator assembly) and the parking brake actuator assembly continue to operate for 20 seconds after the ignition switch is turned to OFF. If a connector is disconnected during this period, a DTC may be stored.
- When removing and installing parts, check for any DTCs to make sure the normal system code is output after all parts have been correctly installed.
Click here
.gif)
- Replacing a part with an incorrect part number may affect the braking system performance or cause an accident. When replacing a part, always use a part with the same or an equivalent part number.
- When servicing the brake system, keep the parts and the areas around the parts clean.
- If the vehicle is equipped with a mobile communication system, refer to the precautions in the Introduction section.
Click here
.gif)
- When the vehicle is parked on a level surface and then tilted to perform work, the parking brake force may not be sufficient. Be sure to pull the Electric Parking Brake Switch Assembly toward the lock side twice (2 lock operations).
HINT:
- The electric parking brake system determines the amount of force used to apply the parking brake based on the incline angle detected by the deceleration sensor (Airbag Sensor Assembly).
- When the Electric Parking Brake Switch Assembly is pulled toward the lock side twice (2 lock operations), the maximum braking force is applied.
Symptom Table
SYMPTOM TROUBLESHOOTING TABLE
HINT:
Use the table below to determine the cause of the symptoms. If several suspected areas are listed, the possible causes of the symptom are shown in order of probability in the "Suspected Area" column of the table. Check each symptom, verifying the suspected areas in the order listed. Replace parts if necessary.
Parking Brake SystemSymptom | Suspected Area | Link |
|---|---|---|
Brake Drag |
Electric Parking Brake Actuator Assembly |