Steering Column

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT STEERING WHEEL HEATER SWITCH

(a) Check the resistance.

(1) Measure the resistance according to the value(s) shown in the table below.

Standard resistance:

Tester Connection

Ignition switch position

Specified Condition

9 (IG) - 6 (B)

switch pressed

Below 1 Ω

9 (IG) - 6 (B)

switch released

10 kΩ minimum

If the result is not as specified, replace the steering wheel heater switch.

*a

Component without wire harness connected

(steering wheel heater switch)

(b) Check that the light illuminates.

(1) Apply battery voltage between the switch terminals and check the steering wheel heater switch illumination.

Standard:

Measurement Condition

Specified Condition

Battery positive (+) terminal → Terminal 8 (ILL+) Battery negative (-) terminal → Terminal 7 (ILL-)

Comes on

If the result is not as specified, replace the steering wheel heater switch.

*a

Component without wire harness connected

(steering wheel heater switch)