INSPECTION
PROCEDURE
1. INSPECT ELECTRIC PARKING BRAKE SWITCH ASSEMBLY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) shown in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
6 (SWI1) - 5 (SW01) |
OFF (released) |
10 kΩ minimum |
ON (locked) |
Below 1 Ω |
Switch not operated |
10 kΩ minimum |
6 (SWI1) - 4 (SWI2) |
OFF (released) |
Below 1 Ω |
ON (locked) |
Below 1 Ω |
Switch not operated |
10 kΩ minimum |
6 (SWI1) - 3 (SW02) |
OFF (released) |
Below 1 Ω |
ON (locked) |
10 kΩ minimum |
Switch not operated |
Below 1 Ω |
4 (SWI2) - 5 (SW01) |
OFF (released) |
10 kΩ minimum |
ON (locked) |
Below 1 Ω |
Switch not operated |
Below 1 Ω |
4 (SWI2) - 3 (SW02) |
OFF (released) |
Below 1 Ω |
ON (locked) |
10 kΩ minimum |
Switch not operated |
10 kΩ minimum |
If the result is not as specified, replace the electric parking brake switch assembly. |
 |
*a |
Component without wire harness connected
(Electric Parking Brake Switch Assembly) |
|
|
(b) Check the illumination.
(1) Apply battery voltage to the electric parking brake switch assembly and check that the switch illuminates.
OK:
Condition | Specified Condition |
Battery positive (+) → Terminal 7 (+) (ILL+)
Battery negative (-) → Terminal 1 (ILL-) |
Comes on |
If the result is not as specified, replace the electric parking brake switch assembly. |
 |
*a |
Component without wire harness connected
(Electric Parking Brake Switch Assembly) |
|
|
Was this page helpful?