Fog lamp assy LH

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.
• Installation is in the reverse order of removal.

1. 1
   REMOVE FRONT BUMPER ASSY
2. 2
   REMOVE FOG LAMP ASSY LH
3. 3
   Remove the 2 screws.
4. 4
   Move the fog lamp assy LH in the direction indicated by the arrow, disengage the hook, and remove the fog lamp assy LH.

a. Turn the fog lamp bulb in the direction as shown in the illustration and remove the fog lamp bulb.

1. 1
   VEHICLE PREPARATION FOR FOG LAMP AIM ADJUSTMENT
2. 2
   PREPARATION FOR FOG LAMP AIMING
3. 3
   FOG LAMP AIMING INSPECTION
4. 4
   FOG LAMP AIMING ADJUSTMENT

a. Prepare the vehicle:

• Ensure there is no damage or deformation to the body around the fog lamps.
• Fill the fuel tank.
• Make sure that the oil is filled to the specified level.
• Make sure that the coolant is filled to the specified level.
• Inflate the tires to the appropriate pressure.
• Place the spare tire, tools, and jack in their original positions.
• Unload the trunk.
• Sit a person of average weight (68 kg, 150 lb) in the driver’s seat.

a. Prepare the vehicle according to the following conditions:

• Place the vehicle in a location that is dark enough to clearly observe the cutoff line. The cutoff line is a distinct line, below which light from the fog lamps can be observed and above which it cannot.
• Place the vehicle at a 90 angle to the wall.
• Create a 7.62 m (25 ft) distance between the vehicle (fog lamp bulb center) and the wall.
• Place the vehicle on a level surface.
• Bounce the vehicle up and down to settle the suspension.

1. 1
   Prepare a piece of thick white paper (approximately 2 m (6.6 ft) (height) x 4 m (13.1 ft) (width)) to use as a screen.
2. 2
   Draw a vertical line down the center of screen (V line).
3. 3
   d. set the screen as shown in the illustration.

HINT:

• Stand the screen perpendicular to the ground.
• Align the V line on the screen with the center of the vehicle.

e. Draw base lines (H line, V LH, V RH lines) on the screen as shown in the illustration.

HINT: Mark the fog lamp bulb center marks on the screen. If the center mark cannot be observed on the fog lamp, use the center of the fog lamp bulb or the manufacturer’s name marked on the fog lamp as the center mark.

1. 1
   H Line (Fog lamp height): Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the fog lamp bulb center marks of the low−beam fog lamps.
2. 2
   V LH Line, V RH Line (Center mark position of left− hand (LH) and right−hand (RH) fog lamps): Draw two vertical lines so that they intersect the H line at each center mark.

   

1. 1
   Cover or disconnect the connector of the fog lamp on the opposite side to prevent light from the fog lamp not being inspected from affecting fog lamp aiming inspection.
2. 2
   Start the engine.

c. Turn on the fog lamp and make sure that the cutoff line falls within the specified area, as shown in the illustration.

a. Adjust the fog lamp aim into the specified range by turning aiming screw with a screwdriver.