Drivetrain

ABS Malfunction (C1296)

~3min read

DESCRIPTION

When a malfunction has occurred in the speed sensor circuit or the yaw rate and acceleration sensor circuit, the 4WD ECU assembly stores DTC C1296.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1296

ABS Malfunction

  • A speed sensor malfunction signal was received from the skid control ECU (brake actuator assembly).
  • A yaw rate and acceleration sensor (airbag ECU assembly) malfunction signal was received from the skid control ECU (brake actuator assembly).
  • Electronically controlled brake system (speed sensor circuit)
  • Skid control ECU (brake actuator assembly)
  • Yaw rate and acceleration sensor (airbag ECU assembly) circuit
  • 4WD ECU assembly

WIRING DIAGRAM

PROCEDURE

  1. CHECK FOR DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)

(a) Clear the DTC.

Chassis > Brake/EPB > Clear DTCs

(b) Turn the ignition switch off.

(c) Drive the vehicle, accelerate to a speed of 20 km/h or more, and check if the speed sensor DTC (electronically controlled brake system DTC) is output.

Chassis > Brake/EPB > Trouble Codes

Result

Proceed to

Electronically controlled brake system DTC (speed sensor or acceleration sensor DTC) is not output

A

Electronically controlled brake system DTC (speed sensor or acceleration sensor DTC) is output

B

HINT:

When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.

B

GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM

A
  1. READ VALUE USING GTS (WHEEL SPEED)

(a) Read the value displayed on the GTS.

Chassis > Four Wheel Drive > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

FR Wheel Speed

Front wheel speed sensor RH reading

Min.: 0 km/h

Max.: 326 km/h

Vehicle stopped: 0 km/h

No large fluctuations when driving at a constant speed.

FL Wheel Speed

Front wheel speed sensor LH reading

Min.: 0 km/h

Max.: 326 km/h

Vehicle stopped: 0 km/h

No large fluctuations when driving at a constant speed.

RR Wheel Speed

Rear wheel speed sensor RH reading

Min.: 0 km/h

Max.: 326 km/h

Vehicle stopped: 0 km/h

No large fluctuations when driving at a constant speed.

RL Wheel Speed

Rear wheel speed sensor LH reading

Min.: 0 km/h

Max.: 326 km/h

Vehicle stopped: 0 km/h

No large fluctuations when driving at a constant speed.

Chassis > Four Wheel Drive > Data List

Tester Display

FR Wheel Speed

FL Wheel Speed

RR Wheel Speed

RL Wheel Speed

OK:

The speed value output from the speed sensor displayed on the GTS is the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).

NG

GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM

OK
  1. READ VALUE USING GTS (FORWARD AND REARWARD G)

(a) Read the value displayed on the GTS.

Chassis > Four Wheel Drive

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Forward and Rearward G

Forward and Rearward G

Min.: -25.10 m/s2

Max.: 24.90 m/s2

Approximately 0 +/-0.13 m/s2 while stationary

Changes in proportion with acceleration during acceleration/deceleration.

Chassis > Four Wheel Drive > Data List

Forward and Rearward G

OK:

The yaw rate and acceleration sensor (airbag ECU assembly) output value is normal.

OK

REPLACE 4WD ECU ASSEMBLY

NG

GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM