How To Proceed With Troubleshooting
HINT:
- Use the following procedure listed to troubleshoot the Dynamic Torque Control AWD System.
- *: Use the GTS.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
INSPECT AUXILIARY BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
|
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
(a) Use the GTS to check if the CAN communication system is functioning normally.
Click here ![]()
Result | Proceed to |
|---|---|
CAN DTC is not output |
A |
CAN DTC is output |
B |
| B | GO TO CAN COMMUNICATION SYSTEM |
|
CHECK DTC AND FREEZE FRAME DATA*
(a) Check for DTCs.
Chassis > Four Wheel Drive > Trouble Codes(b) Check for freeze frame data.
HINT:
Record or print DTCs and freeze frame data if necessary.
(c) Clear the DTCs and freeze frame data.
Chassis > Four Wheel Drive > Clear DTCs(d) Recheck for DTCs.
Chassis > Four Wheel Drive > Trouble CodesResult | Proceed to |
|---|---|
DTC does not reoccur |
A |
DTC does reoccur |
B |
| B | GO TO STEP 7 |
|
PROBLEM SYMPTOMS TABLE
Click here ![]()
Result | Proceed to |
|---|---|
Fault not listed in problem symptoms table |
A |
Fault listed in problem symptoms table |
B |
| B | GO TO STEP 7 |
|
OVERALL ANALYSIS AND TROUBLESHOOTING*
(a) Terminals of ECU.
Click here ![]()
(b) Data List / Active Test.
Click here ![]()
|
REPAIR OR REPLACE
|
CONFIRMATION TEST
| NEXT | END |